Common faults of four foot low configuration automatic rotary cutting machine assembly line

Rotary cutting machine is a kind of mechanical equipment commonly used in woodworking. We should ensure the quality of their products.

The common faults of the card free automatic rotary cutting line are: the veneer thickness is not uniform; the reason analysis is that the rotary cutter is not sharp; the knife position of the rotary cutter is too high or too low; the wood is excessively dry and hard; the cutter bed shakes during the rotary cutting process; the carbon brush of the electromagnetic clutch of the rotary cutting machine equipped with electromagnetic clutch is virtual connected.

Cleaning method: grind the rotary cutter from new blade to sharp, and then polish it with oilstone; adjust the cutting position of the rotary cutter again to the appropriate specific position; use wood with moderate dryness to complete the rotary cutting, and blanch or wet the wood after rotary cutting.

Check and tighten the bolts and nuts of stainless steel fasteners, and adjust the gap between the slide rail adjustment strip on both sides of the cutter bed and the guide rail slider of the cutter bed to a moderate, but not too tight. Turn the carbon brush of electromagnetic clutch downward automatically for 1-2 turns. And fill the oil box with clean thin automobile oil.

Common faults of rotary cutting machine: the size of the remaining wood shaft on both sides is not the same, four foot low configuration rotary cutting machine, the board surface is fan type. Cause analysis: the height of the two sides of the rotary cutter is not the same, the knife gap on both sides of the rotary cutter is not the same; the bearing of the support point of the single flower roller is damaged; the shaft sleeve of the inner roller of the big gear is damaged or damaged. The guide rail seat of the cutter bed is loose.

Cleaning method: adjust the knife height and the cutter gap of the automatic rotary cutting line to the same; replace the single flower roller support point rolling bearing; change the big gear inner side roller shaft sleeve; check and tighten the cutter guide rail seat bolts and nuts.