Woodworking machinery, in peacetime use is more, how should we maintain the card free rotary cutting machine?
We need to pay more attention to the use of veneer card cutting machine. In order to ensure the normal operation of the circuit, we must understand the structure of the card free rotary cutting machine, and do not overload operation when using. When there are problems, we should stop running to check and do a good job of lubrication.
We should pay attention to the use and maintenance of the card free rotary cutting machine at ordinary times, only in this way can we use the card less rotary cutting machine better and play its better advantages.
When the veneer is found to be stuck with the rotary cutting machine, we should also know the corresponding troubleshooting method. We can also take precautions in advance. We should always check the specific straightness of the blade of the rotary cutter, and also check the rolling shaft of the roll diameter and the gap between the knife slots. We should use the rotary cutter reasonably to make the seam consistent with the thickness of the veneer.
The common fault of the card free rotary cutting machine is the uneven thickness of veneer. The reason for this phenomenon is that the single edge of the rotary cutter is not sharp enough, and the wood is too hard when passing through the rotary cutter, and the rotary cutter shakes when working.
Therefore, we can take a look ahead of time in use, often check, to avoid veneer card peeling machine failure. First of all, when installing, take the shaft as the center, use the height of the center line of the clamp shaft as the reference point, fix the rotating bolt on both sides of the machine, and determine the middle height, so that the blade of the blade and the center of the clamping shaft of the machine are on the same horizontal line. After that, just tighten the nut.
Veneer veneer cutting machine is one of the main products supplied by Linyi Guoyu Machinery Co., Ltd. at the same time, the company also supplies a variety of plywood production machinery, such as hot press, planking machine, lifting table, etc.
Contact: Luna Jiang WhatsApp/WeChat: +86 13385391681
Telphone: +86 13385391681 Address: Yitang Town,Lanshan District Linyi city,Shandong Province,China
©All rights reserved by Linyi Guoyu Machinery Co., Ltd