Operation requirements of woodworking machinery and equipment

The manufacturer of woodworking machinery and equipment said that before operating the woodworking machinery and equipment, the oil circuit, circuit and pressing plate of the machine should be comprehensively checked for foreign matters.

Moreover, it is necessary to test run the empty car, check the switches, buttons, valves, limit devices and pressure system, etc., and the operation can be carried out after confirming that they are in good condition. Then, it is necessary to adjust the pressure gauge according to the skeleton of the pressing plate and the thickness of the surface plate. The thinner the plate is, the smaller the pressure is. Note that the maximum pressure should not exceed 8Mpa. The glue distribution of the parts must be even and in place on both sides. The amount of glue application is that the machine passes the glue, and the cloth is applied in place. If it is compressed by a roller, it will be full. The processing objects loaded into the press should be placed smoothly and kept clean. The stacking of the processed articles should be neat and tidy, and the bonding gap should not exceed 2mm.

It is strictly forbidden to hold objects or garbage in the pressing plate and the mechanical transmission part when starting the machine, so as to prevent crushing accidents. It should also be noted that the parts should be placed in the center of the pressing table to ensure that the height under the two screw rods is the same. It is not allowed that the height of both sides is inconsistent or deviate from one side, otherwise the plate will be broken.