best price new rotary peeling machine

As the main equipment for plywood production, the rotary cutting machine is widely used in the wood industry. Like most machines, small problems will inevitably appear in the long-term use, such as the noise generated during the operation, which is quite annoying. Let's introduce why there is noise in the operation of rotary cutting machine with card?

1. One of the problems of the rotary cutting machine is that the bearing is heated continuously and the noise of the bearing is located. The cause of this problem must be found out. If the motor rotor and the wood flour mill rotor are not concentric, the bearing will bear additional load impact, resulting in overheating of the bearing, which will cause the bearing to make a lot of noise in the continuous temperature rise.

2. The ring die is blocked or only part of the die hole is discharged. Mechanical vibration will be caused by foreign matters in the ring mold, out of roundness of the ring mold, too tight gap between the press roll and the die, wear of the pressure roller or damage of the press roller bearing and failure to rotate.

3. If the coupling is not balanced, there is deviation between the high and low sides, the machinery will vibrate, and the gear shaft oil seal is easy to be damaged (the coupling must be calibrated to the horizontal line).

4. If the main shaft is not tightened, the main shaft will move back and forth in the axial direction due to the looseness of the main shaft. The pressure roller swings obviously, the mechanical noise is loud and there is vibration, so it is difficult to work (it is necessary to tighten the butterfly spring and round nut at the end of the main shaft).